How to Erase All Programming From the Low Current Receiver
Overview
In this
article you will learn how to erase all programming from the low current
receiver. This will remove all keypads and remotes that are programmed
to the receiver. Doing this may be necessary when trying to solve issues
where the gate activates and runs.
What You Need
- 2 Long and narrow tools of some sort (paperclips, toothpicks, etc..)
Procedure
Press and Hold P2 Until the Green LED Illuminates
Once the green LED turns on, release the P2 button.
Press and Hold P1 and P2 at the Same Time
You
need to begin holding down both buttons while the green LED is still
lit from the previous step. If the light turns off before you hold both
buttons, start over from the beginning.
After holding both buttons for 2 seconds the green LED will blink slowly 3 times, indicating all programming has been erased.
Confirm the Programming is Erased
Test
a remote or keypad that was previously programmed and confirm that it
no longer operates the gate. Start over from the beginning if they still
operate the gate.
Related Articles
How to Enable Latch Mode on the Low Current Receiver
Overview The "hold" open or latch mode feature should ONLY be used with systems utilizing the automatic close timer to close the gate. In this article you will learn how to enable the "hold open" or latch mode feature on the low current receiver. P2, ...How to Disable Latch Mode on the Low Current Receiver
Overview In this article you will learn how to disable the "hold open" or latch mode feature on the low current receiver. P2, or relay 2, on the radio receiver can be configaured to hold the gate open. In some cases it is desired to disable this ...How to Pair a Basic Wireless Keypad to the Receiver
Overview In this article you will learn how to pair a basic wireless keypad to the radio receiver. The radio receiver is located inside the opener's cabinet. The keypad's code will be entered on the keypad at the same time as a button on the radio ...How to Unpair a Basic Wireless Keypad to the Receiver
Overview In this article you will learn how to unpair a basic wireless keypad from the radio receiver. The radio receiver is located inside the opener's cabinet. The code will be entered on the keypad at the same time as a button on the radio ...How to Unpair a Premium Metal Wireless Keypad from the Receiver
Overview In this article you will learn how to unpair a premium wireless keypad from the radio receiver. The radio receiver is located inside the opener's cabinet. The code will be entered on the keypad at the same time as a button on the radio ...